BONDERITE® L-FG GP 714 (previously known as GP 714 Acheson) is a dispersion of molybdenum disulfide and graphite in water. BONDERITE® L-FG GP 714 dry film lubricant is typically used for wire and rod drawing, cold heading and cold extrusion.

BONDERITE® L-FG GP 714 should be diluted prior to application. The recommended dilution ratio is one part BONDERITE® L-FG GP 714 and one part water. The coils or blanks should be well cleaned prior to application. Hot air blow dryers can aid in the drying process.

Performs under high loads and pressure
Can be applied and cured at room temp
Non-flammable and non-smoking
Heat is not required for dip tank applications
Forms a thin film for higher drawing speeds
Low odor
Non-corrosive and non-toxic fumes
Helps reduce heat on tool surfaces

Excessive Heat on Tool Surfaces & Poor Tool Life
Objectionable Odors from Lubricant
Poor Surface Finish and Defects

Appearance: Dark Gray Liquid
Carrier/Diluent: Water
pH: 9.5 - 11.5
Specific Gravity: 1.18 – 1.21
Viscosity: 2,000 – 2,400 cp
Density: 9 lb./gal
 Shelf Life: 12 months from date of manufacture in original seal